Traktor - Sync phase after exiting loop

DJ Life & Community General Discussion
1

Traktor - Sync phase after exiting loop

After messing around and utilising some micro loops in a mix. I noticed that deck c and a couldn’t re-sync to the tempo? I do not use beatsync in transport options btw
I then researched and found that the option for 'sync phase after loop exit" has been taken out???
I think it was before Traktor 2.5. Is there another work around other than using more cue points?

Was it an issue with timecode that had it removed?

2

You can map the synch command to the loop out button. This way traktor will automatically re-sync your tracks when you exit a loop, making sure your tracks stay in sync.

3

For autoloop button you can set “is in loop” modifier condition to sync.

4

doesn’t quantize fill the gap here? or at least paper over it a bit?

5

HI guys, I am not able to map the loop out to the sync action with the “is in loop condition”.

Could you describe a little bit how to achive that with “tempo sync”. (With beat sync it goes fine, but I want to set it for tempo sync)

My case in particular I would need to set this to the norm.right/left.loop cause my in/out are remapped to pitch bend…

Thanks for your help!

6

Add in Sync on

  1. Set type of controller to button
  2. Set interaction mode to hold
  3. Check invert box
  4. Change interaction mode from hold to direct
  5. Set value to 1