is there problems decoding Traktor Timecode MK2?
i just got some mk2’s and traktor scratch pro 2. but when these time codes play, every thirty seconds or so the signal drops out. and resumes again. idk ehats wrong with the setup.
the Scope just goes blank, and then comes back again. any ideas DJTT?
questions are welcome too.
anyone got an idea?
I assume you tried restarting everything and recalibrating? I don’t think I’ve ever seen that happen. Is it possible the signal from the deck is getting interrupted?
yeah, i tried that. it happens about every one in three times. idk what it could be, but it seems like the signal just cuts for no reason!
i say take your needles off and clean the connector inside the tonearm, or just clean your needles alittle. Check your RCA’s and make sure they are secure? I dunno im just throwing ideas out there
check sample rates in audio settings
What version of Traktor are you using? The MK2’s are for 2.1.1 and after.
“Native Scratch’s new MK2 timecode is compatible with all “next generation” TRAKTOR SCRATCH products when using the free TRAKTOR 2.1.1 service update.”
http://www.native-instruments.com/#/en/products/dj/traktor-scratch-pro-2/?page=3105