tsi mapping problem - assignement table empty

[electrokeun]

tsi mapping problem - assignement table empty

hi everybody

first of all, sorry for my bad english, i’m from belgium.

i have a problem with 3.4 and 3.5 tsi mapping.
i have imported the tsi file several times but when i choose vestax vci100se in the device setup, the assignment table is empty and so the vestax control nothing.

can you tell me if it s because i have a vci100 1.2 and not a vci100se ?

because, when my controller is not connected, i can can see the assignment table of my personnal tsi when i choose generic midi as device setup…

i would like to buy the firmware kit and flash my vestax into a vci100SE but i don’t know if that will solve my problem because when nothing is connected and after importing the new 3.5 tsi, i can’t see the assignment table , but with my old tsi, i can see the assignment table full of commands when i select the generic midi as device setup???

thx very much for helping me

[FlameboyC11]

I had this problem when I was using an version of Traktor lower than 1.24, make sure you have at least 1.24 (1.25 is the current version)

[electrokeun]

thx very much, i had updated traktor but the shortcut on my desktop was still the shortcut of the 1.21 version.

Thx a lot