Twister delay
Hello,
I have a 1 beat delay on my Twister that’s making me crazy 
On my S4 and F1, I have mapped a Freeze Delay to a button and when I press that button the Freeze Delay kicks in on that beat where I press it. But on my Twister, with the exact same mapping setup for a Freeze Delay, the effect “waits” a beat and then kicks in. Very disturbing!
Example:
S4 and F1
1, 2, 3, 4. 1, 2, 3, 4. 1-1-1-1-1-1-1-1
Twister
1, 2, 3, 4. 1, 2, 3, 4. 1-2-2-2-2-2-2-2
What am I doing wrong?
If you could upload the mapping or at least show the relevant bits that would make it a lot easier.
I’ll take a punt on ticking the invert option in one of the commands which will make it respond on release not press.
+1
That has tripped me up on more than one mapping attempt.
I never had that issue with my Twister. Please attach your mapping here in the reply and I’ll give it a test 
Ok, here’s the mapping
I think it could be that everything is changing all at once. if your using an effects preset then just change effect on button push. In my experience when changing effect, the preset is loaded and any instruction to change controls are ignored.
Knob 3 direct value was set to .25
Change it to .3
Should be good then
Thank you it works