Volume LEDs for VCI 100
Would it be possible to buy led volumes and cut them into my VCI-100? Like you get on a mixer, basically to tell me if i’m going into the red…
I’ve googled but to no avail. I vaguely remember seeing someone do it..
Ta x
would be really hard to realize, as you would need an extra connection just for those LEDs + signal processor.
you could map an LED to the clipping on your VCI, i had that on a former mapping, came in quite handy from time to time!
Nice, how did you do that if you don’t mind me asking? Basically i just want to know if i’m going into the red on internal mode.
I’m using the SE mapping so a lot of the buttons are used up but i suppose nay could just start flashing when i go in the red…
What would you suggest?