xone k2 issues

DJ Life & Community General Discussion
1

xone k2 issues

Been having some trouble with my new k2. Whenever I go to set it as the audio device in Traktor…things don’t seem to be working. Can’t get anything to play, and I can only select Output 1 and Output 2 in the output selection settings (Output 3 and Output 4 don’t even show up). The correct drivers are installed (64 bit windows 7), and when I run the analyser, I’m not getting any sound during the headphone output test and the RCA test doesn’t even show up in the analyzer unless I DON’T have any RCA cables hooked up to the k2. :confused: Anyone have any clue what’s going on?

2

bump, still trying to get this thing working properly

3

A new development…when using the K2 as a sound card for just playing music in Windows and the like (set it as the default audio device) it works just fine. No clue what’s going on still…but I guess it’s a Traktor problem?

4

make sure to also install the asio driver/software that came with the disk and set the xone:k2 asio driver as soundcard in traktor.
you can only use all the 8-outs when you have this installed on windows.

5

and be sure to update to the latest firmware

6

You also have to choose what soundcard you want to use in traktors settings. Not just the generic windows soundcard.

7

I’ve done all of this stuff :confused:

8

Try to check if your interface is not beign used by windows, I think you can’t have your interface to output windows sounds together with traktor sounds…

Also try to change the buffer settings to a higher value.

I dunno what else could you do. Have you tried to test the k2 on other Windows PC or Notebook with traktor?

9

Did anyone find a fix? About to dump mine. 28ms latency is about where my internal soundcard is. :angry:

10

Tested it on my sister’s MacBook and it worked fine there so :confused: