Hello
Is there a way to move a loop 4 or 8 bars to the left or right on a track?
I know we can adjust the length of the loops, but I would like control where a loop is on the track.
Thanks
Danny
Printable View
Hello
Is there a way to move a loop 4 or 8 bars to the left or right on a track?
I know we can adjust the length of the loops, but I would like control where a loop is on the track.
Thanks
Danny
edit: didnt realise the section, Dj sb had the answer below.
Well since the question is in the VCI-100 forum I think he's probably using a VCI-100. What mapping are you using?
Yes. You're going to need to map the following commands either to (most likely a pair of) buttons, or an encoder:
- Cue/Loops>Cue/Loop Move Mode- Button, Direct to Loop
- Cue/Loops>Cue/Loop Move Size- Button, Direct to whatever # of beats (or loop, for the size of the active loop)
- Cue/Loops>Cue/Loop Move- either [button inc/dec] or [encoder relative]