Printable View
Hi guys,
If been searching now for hours :cursing: on this and I just can't figure it out (since they changed from Hotcue State).
I map my Hot cues and LED's and they work fine. When I store a hot cue, the LED turns on, all fine there. The problem is when I delete the hot cue the LED won't turn off :scared:
Anyone can tell me what exactly I've got to do to get this fixed. I must miss something but I can't seem to figure out what.
Thx for your help.
Yoeri.
It's changed like many commands in 2.5
Add out > Track deck > Cue > Hotcue # type
Hi Stewe,
That's exactly what I did but it doesn't work, that's what drives me nuts.
Here's one of the versions I've tried. Can you see what I've done wrong ?
Attachment 12112
Hm.. Try adding M1=0 as condition for LED type same as you did for store hotcues.
Done that... nope. Not working. Arrrgghh..... I've seen it working so it must be something that I'm doing wrong.
Try deleting the commands and mapping them again.
Also make sure to set midi In/Out port to your controller.
Did you set range for hotcue type?
Controller range 0-0
Midi range 0-127
No blend checked.
try adding a sending monitor state command twice, one normal, one set to invert.
My hotcues are assigned to buttons which doesn't support LED output so I didn't actually mess with hotcue outputs in 2.5 but I knew it was renamed.
So i tried to troubleshoot it and see what is the problem there. I added only one output for "hotcue # tupe" and it worked. Thing was with controller range, I started from 0-0 and it lite properly.