Any cool VCI 100 MK2 mapping?

**Stewe** · 05-28-2012, 08:34 AM

Originally Posted by oriyong

Yeb, while you were away i will try to add LED's on right side

You can use modifier 3 for right side jog FX. Just set it up exactly as you did with modifier 8.

**oriyong** · 05-28-2012, 08:54 AM

Screen Shot 2555-05-28 at 8.52.43 PM.png

Done here

**Stewe** · 05-28-2012, 10:21 AM

Originally Posted by Stewe

Next you need to do is to add in modifier 8 that will change FX presets for left jog wheel.

Add in modifier 8:
Modifier conditions: M4=1 ; M6=1
Type of control; Encoder
Interaction mode; Relative
Enc. mode: 3Fh/41h
Rotary sensitivity: 30%
Rotary acceleration 0%

Duplicate it and change settings to:
Modifier conditions: ....... ; M8=5
Type of control: Button
Interaction mode: Direct
Set to value: 1

Duplicate it again and change the following:
Modifier conditions: ....... ; M8=0
Type of control: Button
Interaction mode: Direct
Set to value: 4

I did some testing. You need to make a little adduce to modifiers 8 and 3. In both of those blank modifier conditions slots (from quote) set in:

For M8: M4=1
For M3: M5=1

**oriyong** · 05-28-2012, 10:36 AM

Screen Shot 2555-05-28 at 10.34.16 PM.png Screen Shot 2555-05-28 at 10.34.02 PM.png

Done!

**Stewe** · 05-28-2012, 10:49 AM

Nice,

Now lets deal with blinking led indicator for Jog FX. Follow this path: Add Out > Output > Beat Phase Monitor.

Since this is four deck mapping you will add decks A and C beat to modifier 6 button and decks B and D to modifier 7 button.

Beat phase monitor:
Modifier conditions: M6=1
Assignment: Deck A
Controller range: -0.5 ; 0.5 (check blend box)

Modifier conditions: M6=1
Assignment: Deck C
Controller range: -0.5 ; 0.5 (check blend box)

**oriyong** · 05-28-2012, 11:31 AM

Screen Shot 2555-05-28 at 11.20.44 PM.png

done but not blinking in filter button or should we deal with the stock map filter first?

I have attached you the current mapping here

vci100mk2.tsi