Urgent - Problem With The Upgrading

[djbroka]

Hi everybody,

I tried last night to upgrade my VCI-100, I did it like Ean on his video, but it didn't succed, the message 'ERROR: BOOT' and then something else i can't remember. My question is: CAN ANY BODY PLEASE HELP ME WITH THIS??? :O
Does the cable hareness that ean says to temporarly remove has to be reconnected while Firmware writing?

PLEASE HELP ME WITH THIS GUYS, I'M ISOLATED HERE IN MY LITTLE LUXEMBOURG !!!

[JesC]

are you using a usb to serial cable?

[djbroka]

yes i am, is that a problem? :O

[JesC]

I believe you have to change the COMM settings being that usb sends the data faster

here is the post Ean put up. Good Luck

http://www.djtechtools.com/forum/showthread.php?t=1042

[EanGolden]

Please read all the posts in the firmware support section. Almost every concievable problem has been covered there but you really must read the posts. They are all very helpful.

[midifidler]

Hi DjBroka,

The cable which you move to fit the upgrade kit should stay removed untill the firmware update is completed.

Read all the posts in the support section and you should be fine.

PM me if this does not help you.

[djbroka]

hi,
thenks for giving me a hand with this, I did want Ean recommends to do if you hav a serial to usb cable, which is my case, i tried with some other vlues, higher thas '1000' but it didn't work neither!!!

I really don't know how to do this ...

[Untrustus]

this might sound a bit stupid but do you have the drivers for your serial to usb? I couldnt figure out what the boot error was on mine either untill I realized I lost the driver disk.

[djbroka]

oups! i don't have any driver disk... i've bought it on ebay, there wasn't any driverdisk in the package, i think i'll have to do it with a serial ti serial cable ... i'll give it a shot ...

[JesC]

google: driver of usb to serial and the model u have

Good luck