Problem with my xone 1D

[BitterSugar]

Can anyone could hook me up with your mapping? I'm having some issues with it. The top 4 rotary knobs to be exact. I have them mapped to load the set loop, and control the link length. It's mapped fine, but when I try to turn the knob to change the loop length, it goes nuts!! It jumps from 4 to 16 back to 2 and 32, etc... It's not consistent at all.

Any suggestions would really help! Thanks!

[tekki]

BitterSugar, if you have problems with your controller/mapping, please use this forum.

However, I am thinking you have a problem with a defunct.
1Ds are known to have some problems with haywire MIDImessages.

[Yul]

as a guess only: you may not have set up your 1d correctly, you have two ways of setting the unit so the top encoders react either as endless encoders or as 'buttons' (left and right) which is the setting you wanna have. Please read your manual it's explained at the very beginning.

[Redlight]

Yul beat me to it. I had this issue with my MPK49 on Traktor 3. I had the wrong type of control selected for a knob and when I selected rotary all was well.