Master Light Just Keeps Blinking

[raylol16]

I plug my controller in after I had installed the software and the light is just blinking. Windows is telling me it could not install the device and nothing is detected in Traktor. Any advice here?

[photojojo]

Did you update? There's 1.0.1 that you need to update to and new drivers for windows on S4.

[raylol16]

Did you update? There's 1.0.1 that you need to update to and new drivers for windows on S4.

Hm that might be it. Do I just run Service Center for that?

[photojojo]

Yes and then calibrate your jog wheels.

[raylol16]

Before I drive myself crazy...the controller should still be detected and work even if my Traktor software is not registered right? I am just lost as to why it is not even being picked up now.

[VanGogo]

You shouldn't plug it in until you put the update on. I would uninstall and start fresh. Do not plug in S4 untill you are all updated.

[raylol16]

You shouldn't plug it in until you put the update on. I would uninstall and start fresh. Do not plug in S4 untill you are all updated.

I was fully updated and it still wouldn't recognize. I have tried on two different computers now for whatever reason it wont recognize the controller.

[VanGogo]

Dunno. Have you tried a different USB cable?

[manchild]

Make sure you dont have the controller plugged in while youre updating or installing the software drivers.....sounds like you didnt but just trying to be helpful

[raylol16]

I gave up trying to get the drivers to go on my Windows 7 machines. My Macbook Pro however (latest generation) is saying too much power being drawn =(