Hi, Here is my map i have done for all the reloop dj2 owners out there. This map for Tpro 2 will allow you to control sample decks in the 3 & 4 position only, these have to be loaded with decks 1 & 2 or even 3 normal decks.
To use the sample decks via the controller all you have do is press the fx jog mode button, the left for deck C or the right for deck D. I these aren't pressed the controller will function as normal. I have used the 4 loop buttons , the 4 effect encoders and the buttons underneath them. To load a loop into the required slot press the shift and any of the 4 loop buttons (slot 1 at the top down to slot 4 at the bottom) Without the shift being pressed the fx encoders can pressed to start/stop the samples and twisted for volume, the led's will stay on in this mode or you can press the buttons below to retrigger these. The loop buttons now control the playback mode of each sample slot - loop or single play and will be lit in loop mode. When the shift is pressed the push encoders are now used to control the filters for each slot but the buttons underneath them stay as the retriggers for the slots.
Please have a go and give me some feedback of what you think and any improvements i can make.
Attachment 5132
Bookmarks