VCI Firmware 1.1 with SE?

**DoctorMogal** · 05-09-2011, 09:48 PM

Is it possible to use the default factory VCI-100 with the SE mapping?

**fullenglishpint** · 05-10-2011, 06:15 AM

Yes, but you'll miss out on lots of features.

**photojojo** · 05-10-2011, 06:41 AM

Ean talks about how to boot into 1.2 towards the end of this video.

http://www.youtube.com/watch?v=Pq9dp...layer_embedded

**fullenglishpint** · 05-10-2011, 06:55 AM

chris, I think he means a VCI that doesn't have the firmware upgrade.

**photojojo** · 05-10-2011, 06:57 AM

Originally Posted by fullenglishpint

chris, I think he means a VCI that doesn't have the firmware upgrade.

Ahhh, then I refer the OP to the quoted post below which is also above.

Originally Posted by fullenglishpint

Yes, but you'll miss out on lots of features.

**fullenglishpint** · 05-10-2011, 07:00 AM

Winning

Thread: VCI Firmware 1.1 with SE?