Load FX Presets Mapping

[Zeto]

So I searched all over but couldn't figure this out. I have seen many mappings that allow you to load a preset fx chain or a single effect with a button and i want to know how to map this.

For example hitting a button loads beatmasher filter and gater into fx deck 1 then hitting another button loads a different chain of fx.

Then in fx deck 2 i want to be able to hit different buttons to instantly load different single fx.

Thanks for any help guys.
Much love

[photojojo]

Map the button to Effect Select, then map the same button to FX select 1, 2, 3 making the interaction mode for each of those direct so you can choose what effect to load.

[Zeto]

Thanks! Found that in the sticky thread after posting. But now im trying to map the led output but its not working. I set the condition to fx panel 1 group then set each controller range to the FXs respected value in the list. The led turns on when i map it but when i press the button it turns off, then the led comes back on whenever i change the fx. Did i do something backwards?

[dirtystripes]

Well, the LED could be for a few reasons..

1. You might just have it inverted like you said. Try hitting the invert button first and see if that fixes it. If not, it might be a problem with the ranges you are using to trigger the output signal. Fiddle with a variety of ranges and you might find that's your problem.

2. If you're using an APC40 with Windows.. The outputs sometimes turn off when you hit a button. It's frustrating, yes, but that's just the way it is. =/ Sometimes when you hit a button quickly it may continue to light up, but it's far from ideal. +1 for Mac though as they don't have this problem..

Hope that helps.

[Zeto]

Thanks! Ill give that a try. This function is for my stealth control btw