How to map LEDs for loops in Traktor?

[helloskoodle]

Hi

I am currently working on a Radius 2000 mapping project and i am stuck on the LED mappings. Everything else is fine, i just need to know about how i can map the LEDs for loops and such.

I have a row of buttons that set fixed loops. I want them to light up when pressed, and turn off when another one is activated. Also, when mapping the 'In/Out' loop function, how do i map the LEDs so that i hit 'In', it stays fixed on, then when i press 'Out' (and is in a loop), both flash, and when i hit 'Out' again, they both turn off?

Bit stuck here...

Thanks.

[Stewe]

Also, when mapping the 'In/Out' loop function, how do i map the LEDs so that i hit 'In', it stays fixed on, then when i press 'Out' (and is in a loop), both flash, and when i hit 'Out' again, they both turn off?

You need to set one toggling modifier (Mx=1) to loop Out button and map Beat Phase LED output to both loop In/Out buttons with modifier conditions of this toggling modifier. Also you want to set conditions of Mx=0 to both LED outputs for loop In/Out buttons so Beat Phase won't mix signals when activated.

[MrAybar]

Hey stewe u r the man!!!!!!!!!!!! Ill pay for your mapping services!!!!!!!!

[Stewe]

Hey stewe u r the man!!!!!!!!!!!! Ill pay for your mapping services!!!!!!!!

Thanks for support MrAybar!

[xander.skok]

I have a row of buttons that set fixed loops. I want them to light up when pressed, and turn off when another one is activated.

That's what i want to know also... Working on Lemur template for Traktor.

[Stewe]

That's what i want to know also... Working on Lemur template for Traktor.

How many buttons do you use for loops? You might need modifiers outputs to do this trick instead of loop active output.

[xander.skok]

How many buttons do you use for loops? You might need modifiers outputs to do this trick instead of loop active output.

I have 4 buttons... Can you please explain how to do this trick ?

[xander.skok]

Thanx, worked like a charm... Now how i can define outputs of loop active for each separate button...
I mean when i press in traktor select/set loop defined to 2, i want that on my controller, button assigned to this function will on as well. Any thoughts ?

[Stewe]

Thanx, worked like a charm... Now how i can define outputs of loop active for each separate button...
I mean when i press in traktor select/set loop defined to 2, i want that on my controller, button assigned to this function will on as well. Any thoughts ?

I'm not so sure this LED options can be set with Traktor... This is why I gave you modifier setup that will simulate this behavior. You only need to map "loop size+set" command to same buttons as modifier state 1-4.

[Stewe]

I made a short video so you can see how it works. I guess this was the original idea, right?



BCD's LED feedback for buttons in traktor seem to work as toggle by default, so you need to create same one by toggle default for your loop buttons if possible. It's really easy to set one "hold" modifier and it will act like toggle. This have mass advantages like in this example. If you can't create default one, then you need to add four more toggling-0 to your existing directs that you already map in. It should act the same as I tested same those modifier outputs "loop LEDs" with other buttons also.

This mapping contain 24 commands for everything. First try to remap my existing mapping to your controller or eventually add in all commands.

Loop LED output.tsi

I labeled all assignments in comments as in video for better understanding. I will continue to look for other loopLED solution that you mentioned. I think that's not defined in traktor and it is a good feature.