Colored LED Feedbback for Cuepoints on Maschine MKII

[armyofme4340]

Hi guys,

I'm working on a mapping for the Maschine MKII and I am trying to map my cue points so that if a Loop or any other cuepoint type is loaded it gives you the color feedback for that pad.

You can change the Pad colors in Control editor but I'd like for them to give me feedback based on what the cue point types are when you load a track.

Any input would be greatly appreciated. I'm hoping this isn't locked into the NHL protocol.

Best,
Priscilla

[Stewe]

Hey Priscilla,

If that isn't locked up you should be able to set cue LED behavior from controller range. Should be like:

min: -1
max: 5

[armyofme4340]

Thanks for the reply stewe.

The problem is that in the Maschine Controller Editor Preferences (The standalone app not the controller manager in Traktor) There is a slot where you can designate the color and this overrides anything that is done within Traktor. There is an option to set the Midi In for HSB which according to the manual means that all midi feedback is handled by the host software (i.e. Traktor). When I click on HSB though I loose all Midi Out capabilities, in other words nothing I map to that pad works; no led feedback at all.

Not sure what I am doing wrong here.

I've attached screengrabs as well.

Screen Shot 2012-11-30 at 11.52.17 AM.jpgScreen Shot 2012-11-30 at 11.52.24 AM.jpg

[spencer4hire]

How goes this project?

[dcrouse087]

I was also trying to get this to work a while ago with out any luck. Have you made any progress? On an old video I saw DJ shiftee had yellow, blue, and green led feedback on his hotcue's so im assuming there's a way to do it. I opted to just set Both A + B Hotcue 1 pads (I always make them the load markers) permanently as yellow and all the others as blue.

[K Jovan]

check this vid out, I've tried ... but still no luck

[Dubba Dutch]

Bump

Anyone made progress on this? Spent the day wanting to kill the controller editor, now rmx decks are proper map friendly I'm sure there'll be plenty others out there who wanna turn there mk2 Maschine into a giant f1. There must be a solution to gain software mappable access to those rgb pads!?

[Minimal Technique]

Working on the same issue on my Kontrol F1 ... spent hours on it without any positive result.

[Dubba Dutch]

Check the link for some answers on this topic

http://www.native-instruments.com/fo...=187269&page=2

So there is a solution but my god the thought of the hi volume commands to get all the cells to work like an f1 is frightening!