A bit of help mapping out my K2....

[KundaliniRising]

picked up a k2 a couple months back. finally getting around to mapping the thing ( have an s4 as well and been super busy so its easy to push off to the side) and i've got most of what i want done for mapping but i am having a bitch of a time trying to map the top left(set) and top right(set) of rotary push button encoders


these guys

k2 upper controls.jpg

to behave identical to these guys on the s4

s4 controls.jpg

i would want to replicated the mapping of the output of the LED's on the "in " and "out" buttons on the s4 to the LED's (albeit not buttons) below the rotary encoders on the K2.

.....and i did do a search..... came up with this thread and its subsequent links but couldn't really make sense of what was going on in the .tsi or posts....

http://forum.djtechtools.com/showthread.php?t=56324

i think juyce is trying to do the same thing as i am....

thx guys

[Stewe]

Loop 'in' and 'out' buttons:
Add in > Deck Common > Loop > Loop in/Set cue / type-button / interaction-trigger
Add in > Deck Common > Loop > Loop Out / type-button / interaction-trigger

Right knob:
Add in > Deck Common > Loop > Loop Set / type-button / interaction-hold
Add in > Deck Common > Loop > Loop Size Selector / type-encoder / interaction-relative

Not sure what left knob does... Maybe you can give me some input so I can have better idea what to say.

[KundaliniRising]

Left knob is a beat jump based on the size selected by the right encoder, that is to say the right knob adjusts loop and the beat jump size, while the knob does the actual jumping or I guess you could say "seeking". Clicking the left encoder activates a pre set loop already that is already cue marked in the track and the right encoder click will set a new loop at the current selected value.