Hi guys,

dont often post in this area of the forum, as ,mapping is something I have very little knowledge about; hence this question..

I have just "upgraded" my computer to an iMac, which I am using to run Traktor 2.6.1.

I use a reloop contour "controller edition" module to control traktor, as i find its much easier than pushing buttons on the screen during a mix.

It works great, with one exception...

When I am using the four buttons which turn on the effects control knobs, they are triggering the touch pad sounds on my RMX1000, which the contour controller isn't even plugged into....

Can anyone help me and tell me why this is ?

If it helps, this is how everything is set up....

The RMX1000 is hooked up to the master out of my mixer as it doesn't have a send return loop (Behringer DDM4000), and the sound from here, is sent direct to the speakers.

The contour controller, is sent direct to USB on my iMac, and then the resulting signal from the mac is sent to a Behringer UCA 202 sound card-type thing (I think withchcraft happens in here), which is then sent to the channel 1 of my mixer.

I hope this makes sense to someone out there, who may be able to shed some light on my little problem!

I am using the following mapping to run the controller...

http://support.reloopdj.com/index.php/topic,3887.0.html

Any suggestions gratefully received!

Peace Out

ThinAir