DJ D$'s Setup

**dcrouse087** · 03-10-2013, 05:25 PM

Hey guys and (and girls

) I've been meaning to make one of these to show people my gear but I've been lazy.

First up is my VCI-100 which I bought for portability reasons to bring to friends houses. I haven't had it all that long but I bought it with the intention of doing the arcade mod so why wait? I also installed an audio interface and updated the firmware and gave it a white enamel paint job. I'm using a custom mapping I made from "scratch"

IMG_2168.jpg IMG_2169.jpg IMG_2170.jpg

I also have some 1200 MK5's (with upgraded LEDs) and a DDM4000 with an X1 and Audio10.
IMG_2171.jpg 8419401782_41b13ed3ce_z.jpg

**dcrouse087** · 03-10-2013, 05:29 PM

PS: Idk why the iPhone pics are upside down. They are right side up in the preview on both my computer and phone. Thanks for checking it out.

**makar1** · 03-10-2013, 05:42 PM

Nice modding on the 100! I'd love to have a built-in interface too... which one did you use?

**dcrouse087** · 03-10-2013, 05:45 PM

Originally Posted by makar1

Nice modding on the 100! I'd love to have a built-in interface too... which one did you use?

Thanks. I used the NI Audio2. I had to leave out 2 of the rear screws on the sides and put a washer on the one in back on the bottom but it gets the job done.

**cagalume** · 03-10-2013, 07:19 PM

nice ddm4000 man !

**dcrouse087** · 03-10-2013, 07:26 PM

Originally Posted by cagalume

nice ddm4000 man !

Thanks, I'll have to take some better pics with my good camera sometime.

**samplectro** · 03-13-2013, 10:34 PM

Hey! Very nice mod!! Would you mind giving me a little info? I'm looking into doing a mod and yours pretty much has me hooked on picking up a vci!

**dcrouse087** · 03-14-2013, 06:01 AM

Originally Posted by samplectro

Hey! Very nice mod!! Would you mind giving me a little info? I'm looking into doing a mod and yours pretty much has me hooked on picking up a vci!

Sure. I got all my info about the arcade mod on here and ordered the arcade butons from the shop. The interface you basically just put it inside the unit and solder the connectons of the new jacks to the existing ones. Then I recommend buying the chip and doing the firmware update otherwise certain buttons are rendered useless.
If you do get stuck along the way I can help you out though. Good Luck