RS232 to TTL adapter for flashing?

[MixiM]

Hello guys, just looked at the connections and it seems that the VCI uses the TTL type of communication for firmware upgrades... ex:

http://www.nkcelectronics.com/rs232-...33v232335.html

Would a simple RS232 (COM-Port) to TTL adaptor be enough to flash the VCI-100 (of course, making a custom and fitting connection to the VCI itself with 6 pins), or is it not TTL?

EDIT: Yes it will translate the signals correctly but as Ean mentions in the bottom of the thread,unlike the DJTT Firmware Kit , this is only half baked. Constructing and soldering a fitting connection (and not screwiing the pinout) for the VCI is required for it to work!

Regards, Jocke from Sweden

[midifidler]

For sure man

[MixiM]

For sure man

Yup, saw that picture posted by you earlier. Just wanted to make sure it was TTL. Now I know then

Mega thanks from Sweden!

// Joakim

[EanGolden]

just in case someone reads this thread and gets confused. The product above is not a plug and play replacement for our firmware kits:

http://techtools.myshopify.com/produ...-upgrade-cable

the product above must be modified and re-wired to work with VCi-100 but does provide the same essential purpose.

[MixiM]

just in case someone reads this thread and gets confused. The product above is not a plug and play replacement for our firmware kits:

http://techtools.myshopify.com/produ...-upgrade-cable

the product above must be modified and re-wired to work with VCi-100 but does provide the same essential purpose.

Yepp, it is certainly not complete and I have edited the first post to reflect this