Replace small black knobs on VCI-100 with larger knobs

[MaxOne]

Would love to replace the small black knobs on VCI-100 (balance ones) with larger knobs.

Anyone know if this is possible and where I could purchase these bad boys?

Cheers guys and gals

Mx1

[DennisHuiberts]

In the store

[MaxOne]

they're not for the small black balance knobs on the vci-100.

they're for the main knobs, eq, fx etx

Anyone know about the small uns? I've turned the balance knobs into 'echo' knobs that freeze when clicked in the middle. it's just a bit hard to see when they're on or off.

cheers

[sine143]

hmm. I hate those little knobs to be honest, but I have a feeling they are going to be a pain to replace (all the times I've opened up my vci, havn't looked at those). I've just painted the tops with silver sharpie, left the tick black. perhaps you could glue something else onto the black knobs? something a little less round, so you could tell where they are are actually pointing?

[MaxOne]

Yeah I actually pulled a couple of knobs off my DJM-600 mixer which is lying redundantly in the corner of my room and they sort of click on but come off a bit easy.

I'm a bit loathe to glue em on cause i've half a mind to sell the 600 and so want to it to keep all its knobs on.

I suppose I could get some replacement knobs for the DJM600 and use those...

Just was wondering if anyone on here had found a good solution.

They are toliet those little black knobs.

[hurundi]

is it somehow possible to remove those small knobs? i tried to pull them off without success and i'm affraid of breakting something if i add more force.