APC20 LED Mapping
hi i tried to map my APC20 but the led feedbacks are not like number i wrote.
for example i mapped the “set loop” to led red when its off and when its on i should be green.
but the led gives me only one color green or in invert red.
some one know what can i do?
tnx
If I remember correctly your APC need to be in “dumb” mode.
what is that ‘dumb’ mode?
didn’t traktor 2.5 fixed it?
I found this. It was originally posted by photojojo:
Midi value
0=on
1, 7-127=green
2=green blinking
3=red
4=red blinking
5=amber
6=amber blinking
To change the way the LED’s on the knobs act.
0=off,
1=Single,
2=Volume Style,
3=Pan Style,
4-127=Single
And thread: APC 40 Traktor 2 LED's
If you have just an APC20, don’t plug in the power supply; only connect it via USB.
If you have an APC40, you have to start up Ableton with the APC40 as a control surface. When Ableton recognizes the APC40 and uses it as a control surface, the APC40 goes into “Ableton” mode. Closing Ableton will make the APC40 go into “dumb” mode.
can your APC20 work without power supply?