Are these the correct cables?

DJ Life & Community General Discussion
1

Are these the correct cables?

I’m hoping my fellow DJTT’s can help me out. In a couple days I’m going to have to connect my setup into a xone 32 mixer and need help on which converters I need.

Current Setup:
Motu Ultralite firewire 12 (1/4") in 14 (1/4") Out
MBP OSX
VCI-100

I figured I would just use the left & right rca wires from the mixer into the back of my soundcard. I bought these rca-1/4" stereo adapters but I’m not sure if they will work. Do I need the rca-1/4" stereo or rca-1/4" mono?
Channel A will be set to 1&2
Channel B will be set to 3&4

2

each 1/4 output is mono, u will use 4 outputs for 2 stereo outs, so u need two cables each have two 1/4" on one side and two rca on the other end

3

Thanks for the reply. I’m going to exchange them tomorrow.

4

i should have asked if you plan on mixing internal with the vci100 or externally on the mixer?

I was assuming you were planning on mixing externally, but if you are doing it internally then you only need one of the above cables.

5

Wait… why would he need four cables to run into two cables?