Flux mode KONTROL S4 [Need Help]
Hello,
I need help on get it working i don’t know what wrong.
Well i’ve mapped the flux mode on when i press shift + loop active mode… What i want is when this mode is active whenever i press hotcue 5-8 it act on loop for the flux mode:
-hotcue 5: x1 loop set
-hotcue 6: x2 loop set
-hotcue 7: x4 loop set
-hotcue 8: x8 loop set
I don’t really know what’s wrong with mine i can’t get it to work properly… Please help me.
Did you add loop set command for all four hotcue pads?
Yes already.
Well the hotcue acts like start and stop button i’ve set it on direct mode…
You might need to disable hotcues while performing on flux mode.
Sorry i mean when i push on the hotcue button to launch the loop it work like start and stop button…
What do you mean?
it work like i’ve to push on it to start then push on it to stop.
‘Loop Set’ with interaction HOLD should do the trick. If you can’t get it right I’d make sure if some other commands mapped to same pads are conflicting there. Just to test things you should start new mapping device and map only this feature.
Okay i will try as soon i get home and ssend it here..
I don’t know what i’m doing wrong but it’s still not working… The loop is activated without being in flux mode… Plz help
Up.. Any help please?