I’ve been using a Vestax VCI-400se for awhile now, and I’ve gotta say. All of the mappings I’ve found have been awesome! I was stoked to discover I could use multiple midi mappings in Traktor at once. I decided to plug in my 25 key Berhinger controller, and make a simple mapping. I found this awesome DJTT article from a few years back explaining how to do this properly.
My mapping was simple. Two knobs controlling the “key” perimeter of Decks A and B. I’m pretty sure I followed all of the directions, but when I imported the new mapping for my Berhinger, the play buttons on my VCI-400 stopped working is there something I’m missing? What could I have done wrong? Any advice would be greatly appreciated. Thanks!
For multiple mappings, you should use Preferences>Controller Manager>Add..>Import TSI>Import Other
If you use the “Big Import Button” this will wipe any mappings you have and replace with the new one.
Thanks for influencing me to look into this further. I had already done what you suggested, and that’s when the problem occured. It’s interesting that my solution goes against what the DJTT article says to do. I set the input and output for the VCI to itself (VCI-400se) as suggested. However, for the Berhinger, I set the INPUT to itself (UMA 25s) and the OUTPUT to the VCI-400. Im not sure if I’m just a noob, or if it’s because I have an older version of Traktor. But it worked! I hope this helps anyone else who is having issues routing their mapping to their audio interface.
is there something I’m missing? What could I have done wrong? Any advice would be greatly appreciated. Thanks!