Looking for a X1 mapping: Control all 4 decks via single X1
Been searching all over, nothing found sadly
Ideally I’d like to control decks A & B normally, and C & D in Midi Mode on the X1, both on the same X1, exact same functions but just different modes for different sets of decks (all timecode vinyl in every deck)
anyone see this around anywhere? Thanks!
(Traktor 2.5 or 2.6, A Single X1 Kontrol, 4 Turntables via Timecode Vinyl)
Any luck finding it at Traktorbible site?
No luck, actually tried that one already, it controls FX for them in midi mode but no hotcue functions for C&D
alrighty well I’m learning to map it out myself, but I’ve run into a situation, anyone care to chime in?
We all already know the shift button is mapped to switch to midi and back again
well when I’m in midi mode, I want to map shift to act like normal so I can set it so I have to hold it and hit a cue point to delete it. I can’t map the shift button in midi mode to the shift button! I can map it to every other button and my cues delete as normal, but I’d like the shift button to act as the shift button. Is this because it’s already mapped as the X1’s (normal mode) shift button?
That is correct. You need to use any other button for shift function.
No. It is firmware thing just like with S2 and S4.
Thanks Stewe! Sucks but looks like I’m learning a lot, thanks again for all your help homies
now onto my next task, mapping the loop and browser buttons accordingly, should be a nice pain in the ass!
If you need any help let me know I have mapped my X1 many times. Looping took awhile…
Thanks! Any advice on the looping or browse features would be greatly appreciated, especially since I like to hold shift and use the browse wheel to skip back/forward in a file as it’s playing