Numark Omni Control - need help for monitor cue buttons mapping
Hi everybody.
I’m asking to have some help for mapping the monitor cue buttons for the Omni Control using Traktor pro 2.1.1.
Suppose I have the monitor cue button for deck A on. I would like to have the monitor cue for deck B (when pressed) to automatically switch off the one for deck A and vice-versa.
I’ve already played with modifiers and tried different settings without any good result.
Any help is appreciated. Thank you.
they’re not mutually exclusive, i.e: u can monitor all 4 decks at the same time if u want to. so all u need to do is as well as turning ‘on’ headphone cue’ing for deck A when u press it’s button u also need to map turning ‘off’ decks b+c+d (if u use all 4 ofc) to the same button.
use mode=direct, then u can map those 4 controls to the one button, one to enable cue’ing on deck a with value=1, and the other 3 to turn off b/c/d with value=0. rinse and repeat.
Thank you very much zestoi.
This worked fine. I didn’t realize I could assign the same button to different decks.
actually i wasn’t sure myself until i fired up traktor and checked 