Numark Stealth LEDs
Does anyone know how to map the Stealth control in Traktor so the LEDs come on. I’ve tried omni control maps, I just don’t know…
theres mappings on the numarks site and a few pics of the led midi commands, which can be found here
http://www.numark.com/content228769.html
and here
http://www.djtechtools.com/forum/attachment.php?attachmentid=1206&d=1248862418
heres my tsi with leds enabled, i use the “key” button to switch master sync control, as i always have keylock on, the load track leds blink with tempo, and effects should work on both sides, oh, and the gain knob is my filter.
edit ::: pitch +/- enable fx slot 1/2 for each respective track.
hit me back if u need anymore help 
Hey thanks…
I forgot to mention that I use Traktor 3 Dj studio. Is yours for PRO. What do I need to do to adjust.
I downloaded the Traktor 3 map from numarks site. I’m using it as is. I just don’t know how to map the leds. Betatron, I would be forever in debt to you if you could explain how you did it (especially the track load buttons, blinking to tempo). That sounds great…
awww sheit, im in tpro… and i really dunno a thing about t3 i started out in tp 
I believe the midi setup page looks the same in both programs. Do you remember how you mapped each one as in channel assignment and shit like that. Basically I’ve been chugging through trial and error and so far nothing. So any guidance is appreciated.
are you setting them to output and putting the correct midi note in?
yea and then it doesn’t work. And when I go back in to midi setup the bar is highlighted in red. Arghhh. This shit is driving me crazy. Does anyone have Traktor 3 .tks file that has working LEDs
Below is a table that I used to help with getting the LEDS to work. For me, it was really annoying when I first tried setting the controller up.
Numark Stealth LEDs
If you want, you could take a look at my .tks file (more info)…it’s not complete but it might be able to help you somehow but the LEDs work. I’d finish it but moved to Traktor Pro.
if it the same as the omni…
I appreciate the help. after I use the assignments from the chart, what do i do? What channel do I put them on and any other settings to know about. I don’t know whats going on, because it seems like I’ve tried everything…
ive had a problem with my stealth aswell, finally got most of it working.
the only problem ive had is with the “fine pitch” dial which i just cant seem to find a set up for.
any ideas?
hey guys i#m using the numark stealth control, i took the tsi file for the omni control and the settings were great, but the led’s arent working, has someone got the tsi with working leds?
i#m searching for this since 1 week, hope you can help me
Nice feature! I really want to integrate it to the tks file I just made for me and the people who are struggling here…
I need to know the midi command you are using for this one and its’ properties…
Thank you!
I second that
Here 's what I did.
I took the tks file from numark’s site and erased one bunch of useless (IMHO) commands. Then restored PFL, KEY, SYNC (trigger), TAP, FINE PITCH. Last, I assigned balance at PAR, FX on/off at FILTER ON/OFF, FX amt to FILTER AMT, FX selection to SELECT and the second knob of the effects to FX AMT. I left unassigned the ON/OFF button under PAR, which could probably be the blinking tempo led…
As you can understand I am really new to this and my only goal was to obtain an easy to use controller. Maybe, when I 'll get more experienced, I will provide you a more sophisticated tks.