Problem: Nested Modifier States in Traktor?

DJ Software & Apps Controller Mappings
, ,
1

Problem: Nested Modifier States in Traktor?

Hey Guys,
I am running into a little bit of an issue here.

Its better if I explain it as … this part is basically a toggle button between Modifier and M1 > M0

Modifier Button A: Sets M1=1
Modifier Button A: Sets M1=1 Back to M1=0

I am using Controller: Button, Mode: Direct and values 1, 0

Problem begins when I try to temporarily put another modifier state M1=2 while I am in M1=1 with Modifier Button B. Here I am using the Hold Mode because I want to get the state back to M1=1 when I let go of the button. But the state gets stuck at M1=2 and does not switch.

I am using this to switch between FX modes, single to group and back. So the knobs are temporarily switched to Effects selectors for the three slots then back to Dry/Wet for each effect. I plan on using 4 modifiers for the for fx slots and switching modes independently.

Is there a way around it?

2

Set your second button to M1=2, then set value go back to 1 (with invert)

3

Nothing…

Does not work… unless I am doing it wrong.

Mapping here. https://drive.google.com/file/d/0B0VyuS3OVC0pVnp2QTI1elRuMjQ/view?usp=sharing

4

Fixed it. Let me know if that’s what you’re after.

MappingProblem_Edit.zip (32.2 KB)

5

This has the same effect as the one I made.

Hehe… I actually fixed it :slight_smile: You forgot an invert send from Button B.

Thanks man!

6

You Welcome!

I know - figured that out after uploading so I made another .tsi file right under the zip :wink: