Setting up Timecode in TSP2
How do i do it, im kind of a noob and need a step by step on how to setup my stanton tables with my s4. Please help!
kind of fixed it
ok i beleive i figured out how to hook up the right inputs but think my singal is not sufficent enough because it shows the orange calibration moving a little but not fillin up into a circle. any suggestions?
Please help grounding!
Everyone is probably looking through this forum going why is this hayden14 guy still posting random stuff. I have one question i found out why my tables and timecode arent working properly because i havent grounded them properly. Where do i ground them on the S4. There arent any grounding screws on the S$ it seems, there is one bolt that turns in and out that could maybe work but then that would only work for one table… what do i do? please help with grounding!!
Switch the switch in the back from line to phono. You should see the circle.
I have it on phono and it shows a small fuzzy dot tthat moves a little but doesn’t quite form a circle, im prettty sure cuz it needs to be grounded. Any idea where on the s4 I should ground it?
it’s on the outer side (far right hand side, when looking at the S4 from top/front) of the “Main Out” section, as per the picture at NI. There’s a Kensigton lock hole above it. That’s on the back panel, of course.
my S4’s not with me to confirm it …