Traktor and CDJ 2000s

DJ Life & Community General Discussion
, ,
1

Traktor and CDJ 2000s

Hi Guys, long time member, haven’t been around much but was looking for a hand with something.

My buddy has a set of CDJ 2000s and a DJM 900SRT that I was attempting to link them by HID to Traktor (2.6.5 on a 2011 Macbook with a 250 SSD and 8gb of ram on OS Mavericks). I am able to get an HID link but sound only comes out of one of the CDJs, all output routings look to be just as in the video and i have control over the decks but the master is coming out of just B.

Did I not aggregate the sound card correctly? any ideas?

Thanks! and its good to be back!

2

Is there a reason why you’re not using the mixer’s sound interface?

3

does the SRT support traktor? I read it didnt without another audio card which is why I am trying to use the 2000’s as soundcards.

4

Every sound interface can work with Traktor. But only Traktor certified interfaces can work with timecode.

5

So youre saying to use the SRT as the soundcard but still link the 2000s to traktor and run them HID as controllers? Ill give it a shot.

Edit: also the firmware was not up to date on his 2000s so we updated that and will see in a bit when I try it again.

6

Yes this is how I would route the audio. Plug in the 2 CDJs via a USB hub [HID mode], and use the mixer as the soundcard for Traktor. Much easier than aggregating the CDJ soundcard. :sunglasses:

7

Maybe you did aggregate wrong, just download the Pioneer’s aggregator tool and test it, it may work. It’s a ready-to-go aggregator device.