Hello there…
As u can see from the title what I need is an advice of how to hook up my Traktor S4 and Komplete Audio 6 to my speakers(Rokit 5) so I can use them both independently from one another(S4 for Traktor,and KA6 for Ableton)and(without the s4 as agregat device for Traktor) so I was thinking that the best way will be by plugin them in some mixer though I don’t have an idеа what mixer exactly will be good.
The inputs on the KA6 are enough for me so I’m not planing to use the mixer from anything different but “bridge”.
So am I on the right way,will it work?
If yes,can u pls recommend me the right mixer to a maximum of 100-150£?
Run the master out from your S4 to the inputs 1 and 2 on your Komplete 6 with monitor turned on. Run the outputs 1 and 2 to your monitors. Now you will have the audio from both.
I use that as sort of sub mixer for my volca set up, cheap cheerfull sounds good. All 4 volcas plugged in then out put to djm750. So you could s4 to channel one and ka6 channel two then output to speakers
Oh god, no. These things are trash. I have one and immediately upgraded to a small mixing board instead.You can probably pick up a preowned Xenyx for a bit more than the cost of the MX400.
It’s also important to know that the MX400 is mono output.
^This!^ Sometimes… The very best and most reliable options are simple and don’t require spending money you don’t actually need to. Good stuff, Bastlet! 10 points for a Veteran response/at very least well researched before responding… response. Lol
to my speakers(Rokit 5) so I can use them both independently from one another(S4 for Traktor,and KA6 for Ableton)and(without the s4 as agregat device for Traktor) so I was thinking that the best way will be by plugin them in some mixer though I don’t have an idеа what mixer exactly will be good.