Traktor Scratch Pro with Timecode Vinyl Problems HELP
Hey there,
For I’m using a pair of Gemini XL 500ii’s with a Numark N4 as an interface.
One turntable shows a perfect scope but the other doesn’t (see picture for what it does show)
Not sure why this is? Ive replaced the rca and ground cables and also the needles and it still plays up.
Anyone else had a similar issue? Anyone know how to resolve it?
Please Help
Thanks
James
3 more things to check as far as I know:
Make sure the needle is actually in contact with the timecode vinyl. Sounds simple but once it took me awhile to figure out this was my issue.
It could be a bad needle or a bad connection with the needle on the headshell.
Is the timecode vinyl good. Test both vinyls on the turntable that is working properly so you know that is not the issue.
Hope this helps in some way.
nice picture saved typing it out
Traktor Pirate? I’m lost. I think I must have missed something.
read the OP and think about it hes running scratch pro on a non supported interface the only way to achieve this is to run a cracked version on the software.
Right, but it doesn’t mean he “pirated” the software. You can purchase it legitimately, then make some registry changes (“crack”) that allow non-certified mixers/interfaces to be used with the program. Either way, NI is losing out on some money, so I guess you could argue that it’s still stealing.
EDIT: Not defending the OP, by the way. Just clarifying.
