Two controllers with Traktor 3 ?

DJ Life & Community General Discussion
1

Two controllers with Traktor 3 ?

Hello,

I just bought the vci-100 and I have the Feena controller as well. I would like to use both controllers with Traktor 3, vci-100 for decks A&B and Feena for C&D.
Your time appreciated,Dj Chuy

2

check this:

3

I think he is also asking, how this could be done?

4

use seperate MIDI channels, e.g set the VCI to send out messages on channel 1 and the feena to send on channel 2.
This avoids any conflict bewtween the two devices. You can then assign your controls as normal in Tracktor.

5

i use two controllers. you don’t have to use separate midi channels, just make sure your not sending the same CC number from different buttons.

6

Changing the channel is 99% of the time a sure fire way of not getting conflicting midi message - I use Midi-Ox to do this personally. Do the remapping in the data mapping section then apply it in the port routing window. I personally do this so i do not have multiple instances of Bomes open for each device.

7

i use 2 trigger fingers, identical devices on identical channel settings. so i had to change the channel for one of them..voila no conflict. total of 4 midi devices at a time.

8

Nice 1 lofi!

Can imagine triggerfingers are doing the job quite adequately! :smiley:

9

So how to change the channel on VCI?

So is there any non-software translation way to change the channel on the VCI-100? I am quite keen on running 2 vci-100s

If not whats the best software for doing this on OSX? Midi-Ox seems to be a windows tool?