I don’t even want to think about how long i just spent putting this together.
Modifier 1 Value 0 is straight decks.
Modifier 1 Value 1 is basic cue set up and jumping
Modifier 1 Value 2 is cue juggling on 5 cue points
Modifier 1 Value 3 is Basic Chained Effects
Modifier 1 Value 4 is Advanced Effects
It’s for VCI-100 v 1.2
It isn’t done yet. Modifiers are selected by pressing the black loop buttons, lights go on. I figure you guys can get through it on the basics. Not everything has been done (no pitch fading, etc.) cause I barely have the energy to keep my eyes open right now. It’s kinda cool, just gonna take some practice.
Well, it all comes down to practice. Really, I’m going to be using more. Now I need to set the values to switch between Decks A/C and B/D, and then I’m going to start playing with adding my PadKontrols into the mix, which are going to make things even more complicated, but give more control to my fingers
Here is my custom mapping for VCI-100 on Traktor Pro. I have tested lots and I think is one of the most complete around. It includes instructions in Spanish, is quite easy to understand and intutive…
I knew it would pay off sooner or later to take part in that Spanish course…seems like sooner since the course started 1 week ago and there was only 1 lesson so far.
