About echo & slice effect and other one’s too
I just ordered and received vci100se. it work’s good but when i try to find those fx, echo or slice, that are but on quick buttons i dont find those at all from my tracktor. and presetted fx are quite different than on video. Do i have to set those by myself? and where i can set those? and when i pres those reverb filter lfo gater delay whit shift i dont get same fx that button says, quite much different one’s
Yarsky
Finland
try to import the tsi again. it ussualy need to be imported a couple op times for the fx to work.
good luck(and welkom on the forum!)
I found sollution to that those weren’t on place. You have to adjust those fx to be in same order that on ean’s video if you wan’t those to work as same as on video…
Just import the TSi file twice to get the FX to load properly as presets.
Freezing Cold!
Hope this thread isn’t dead yet!
Talking about dedicated FX Buttons. Is it suposed to freeze the song everytime you tap the jog wheel with the Echo Button? I mean, if you wanna play with the rate parameter w/ freezing the song, what should you do?
Saludos!
I think you need to find it in the tsi mapping and change it on the command.
Hey, thanks for the fast response!
I’m starting with the .tsi thing. Would it be one of these commands? “ECHO Feedback Hold w/ Jog Tap”?
sorry really not sure without looking at what its doing. If you can find what note the platter gives out then you could then order the midi commands by the note collemn and narrow it down that way. I think the notes are in the manual.