Behringer CMD MM1 + 2 x PL-1 (Mappings and PL-1 problem)

DJ Gear & Hardware Hardware: Controllers, Mods and Gear
1

Behringer CMD MM1 + 2 x PL-1 (Mappings and PL-1 problem)

Hello. Sorry for my english ))
I have CMD MM1 + 2 x PL-1.
I try to set up Traktor with TWO PL-1 and I have a problem. Traktor always sees only one PL-1. If I connect oly one PL-1 and upload tsi from off site all good. Then I connecting second device and upoloading tsi for him all seems good, but after reboot of Traktor only one device is working.
My spec:
OSX El Capitan
Dell Latitude E6530i7-3740QM10GBHD4000+NVS5200MBCM94352HMBHuawei_EM770_WWANIDT92HD93BXX*Intel_82579LM
Sound:
Scarlett 8i6

If some one have mappings for Behringer CMD MM1 + 2 x PL-1 (full setup or parts) feel free to upload or give me a link pls :slight_smile:.
Where I can read descriptions of mappings?

2

You need to change the MIDI channel for one of the PL-1s. By default they all send the same messaging. You can do this by either using the CHANNEL CHANGER SOFTWARE from Behringer, or send one of the PL-1s the following SYSEX message - F0 7F 00 03 01 F7

Other things to try…
(1) Make sure that you’ve selected the IN PORT and OUT PORT correctly for both PL-1s.
(2) Rename one of the PL-1 TSIs and try that.

3

Ensure both mappings have seperate names and change the channel of on e of the PL1’s. I had the same exact issue.

4

1 PL is on HH0 group (1-4)
2 PL is on HH1 group (5-8)
As U can see I have separated names and mappings, but after restart traktor only 1 PL is working.
Midi activity led is blinkin when i press buttons on 2 PL, but nothing happens in traktor.
the_bastet, Do U have mappings? Can U upload them for me?
Screenshots Imgur: The magic of the Internet

5

It’s probably just this^

6

I select correct in and out, but after Traktor reluanch only one is working. I figured out that i need to select this one more time. And now I have situation - before I start to play I am always must select this in’s and out’s. WTF? Traktor forgets which PL1 belongs to which TSI setting. How I can repair this?

7

I came to club and, wait, I must select IN and OUT! WTF!:rage::smiley::laughing:

8

Did you swap the usb ports? If so be sure to connect your PL1’s to the same ports every time.

This seems to be a general issue with midi controllers - not just PL1.

9

I am using hub on MM1. Left Pl is connected to left usb and right to right. I swapped them left-right and right left. With no result. I thing this is Traktor problem. I try to update him from 2.9.0 to 2.11.0.