Behringer DDM4000 Assembly
Hello all, just took the cover off my Behringer DDM4000 and I’m having difficulty getting it back on properly. The outer panel goes back on just fine but I can’t seem to get the circuit board underneath to a high enough level, it just sags back down and I can’t figure out what it was that was holding it up to within a few centimeters of the outer panel. Has anyone ever had the same problem?
Any input would be appreciated.
Thank you
Not opened one myself but perhaps the front panel was screwed on to the motherboard, therefore keeping it up?
look at this picture http://www.behringer.com/assets/DDM4000_P0167_TopPers_XL.png
there is quite a few screws in the faceplate, some of those got to be for holding up the knobs and stuff.
That’s what I was thinking but I’m having a hard time trying to hold the circuit board at a high enough level to the main one so as to get a screw in. To place a screw in to the top board, it has to be placed flat on to the mixer, leaving the circuit board sagging down and well out of reach.
