CDJ vs. VCI. Jog wheel response (calling all scratchers)
Ok, so I’m playing in clubs and 9 times out of 10 the mixer has a shit crossfader or a fader that doesn’t even work. This leaves no scope for me to properly scratch or show off considering they don’t even have proper TT’s, only CDJ’s. I’m thinking it’s time I get involved with this VCI lark after seeing you can scratch on them.
Before I invest and end up being disappointed, how close to scratching with vinyl is the VCI? What is better/more responsive to scratch with out of a CDJ 1000 or a VCI? The CDJ’s I think are ok but aren’t the greatest, you can scratch but you can’t get right in there like with the control vinyl. Bigger hand movements are required in my opinion. How is it with the VCI? Can you really get in there with the smaller scratches?
What about the TT’s break speed, can that be adjusted like on a CDJ? I want to be able to mimmic the switching off and slowing down of a real TT.
Basically I want something that best suited to battle DJ’s and Turntablism. Is the VCI the best to go for or is there something else on the market to go for?
Any help greatly appreciated
the VCI 100 w Traktor is not meant of scratching. It actually sucks for scratching. THe best controller for scratching at the moment is the NS7 with Itch, there’s no controller on the market that works with traktor that provides good scratching. The VCI-300 and Itch is decent for scratching but no where near vinyl.
@ Haze. Really? That’s a bummer. I need something portable and not as expensive as that. I saw this vid which kinda sold it for me.
He says the fader is good yet there is software latency, but he wasn’t running Tpro. I was hoping there wasn’t as much latency with my set-up (2.4 macbook TPro & audio 8). Can anyone confirm how good or bad the jogwheel response is? The crossfader looks fine. But is the VCI worth getting for a scratch DJ? I’m not expecting the earth but just to be able to pull off moves better than on a CDJ.
@Phil. Not really interest in the 300, doesn’t have enough rotary dials for FX etc. I think the 100 is more suited to my style of mixing
There isnt much latency if you set the thing up correctly.
You can pull off moves better on a CDJ than you will on the VCI-100, the 300 has a better response but doesnt yet work with Tpro as well as it could.
You can also get better scratch performance than what is showed in this vid, he is rather using firmware 1.1 or firmware 1.2 but with the .tsi incorrectly setup.
To be fair I don’t think the scratching is that bad in the vid considering what he’s working with. If I can get better response then what is shown then I’m happy. I have a residency in a club with a proper shit mixer for any kinda turntablist type shit so being able to do something is better then not being able to do anything at all. All I can do is faderless scratching at the mo. I’d like to be able to show off a bit more then that.
What about break speed FX. Like switching off a TT and letting the track slow down. Is that possible? And what about drag scratching, or what ever its called… when you put a finger on the vinyl and pull it back with your other hand letting your finger vibrate the record to getting a fast wobble effect?
I don’t have access to vinyl timecode, this is the problem. Only CDJ’s. But are you saying I can use the full function of the mixer section within the VCI yet run the timecode CD’s? So basically sack off the club mixer and use the VCI for the cross fader and the CDJ’s for the jog wheels?
Sweet touch. Ok, so one more question. Just how responsive is the cross fader? If I do a mod to tighten up the lag am I gonna get battle fader response with extra sharp curve?
