Controlling Live 8 & Traktor 2 using only 1 controller
Hello djtechtool readers,
Inspired by this tutorial “Smart Mixing Traktor into Ableton - 4 Mac - DJ TechTools”
I started experimenting with recording mixes made with Traktor Pro 2 routed into Ableton, using jackosx, with promising results !
But I’d like to take it one step further.
I’dd like to mimick Serato’s “Bridge” to Ableton, using only 1 controller.
Assuming Ableton doesn’t allow recording midi-messages sent to traktor’s internal mixer, I’ll have to bypass this by using Ableton’s faders and effects.
This is possible with separate controllers connected to 1 computer (Mac in my case), but doing the same with only one controller (say an S4 in midi mode) would require midi splitting or midi routing software.
Is this midi-splitting done by software even possible to begin with ?
If not can it be done with OSX internal audio/midi configuration ?
Or, do I need separate software ?
But once Traktor starts running, Ableton stops receiving midi messages from the S4.
Also I noticed the S4 midi input dissappears in Ableton’s preference menu, once Traktor starts running…
Thats why I asked about the midi router (software)…
Doesn’t the S4 run in HID mode when connected to Traktor?
I figure you can use it for MIDI when running Ableton, yeah: but starting Traktor bumps it back in to HID, without support for both protocols at the same time.
I’m affraid Padi_04 has it by the right end with traktor starting HID-mode..
Today I tested the same scenario with a vcm 600, it goes where I’d like to get with only one controller. But the VCM is far from ideal for track control. Anywayz…
Maybe there is a solution by first running traktor, then setting the S4 (back) into midi-mode using the shift-browse combo, but then i assume the jogs will only send low-resolution signals. Ay, no me gusta
Would it be a good idea to fire this scenario at NI’s support ? Or will this end as a rhetorical question ?
If so my S4 goes out the door, I need a decent interface for Traktors decks
With the S4, options are very limited-> Low jog resolution and even some noticeable latency, and traktor doesn’t allow sharing the controller.
With the VCM no problem at all.
I don’t believe this is true. From what I remember, midi forms a sort of handshake with the program that’s using it, thus preventing other programs from using it at the same time. You need to route the controller into bomes or midi ox or an equivalent and then route it out from there. I wouldn’t recommend using an s4 since it works on native protocol as well as midi and unless you’re running it all midi that will complicate things. The toggling between midi and native as mentioned before will work though.
