DJ Tech DJM-101 LED mapping in Traktor pro 2

DJ Software & Apps Controller Mappings
,
1

DJ Tech DJM-101 LED mapping in Traktor pro 2

Hey guys, i’m new to this forum and I need help mapping my LEDS for my DJM-101 DJ Tech controller. I have everything working except for the Led’s. Can u please help me?

2

Check out this thread.

3

Ty FrankieFilth. But that is not what im looking for. My problem is with the Master level LED’s. on the DJM-101, not the CDJ-101.

4

Oh, my bad.. Had a long night. I’ll see if I can come up with anything useful for ya!

5

I came across a thread somewhere that mentioned CC’s 80 + 81 on Channel 1. Not sure which LEDs this is in reference to, might be the PFL buttons. I assume that all of your controls are on CH.1??

Will be a pain in the ass but, you may want to get your output commands set up, then go through every CC# (on CH.1) until you get the levels to show, trial and error.

6

I can’t find the manual for this controller anywhere online… Seems that this controller is no longer supported by DJTech.
Do you have the manual that you can share with us?

7

@Rueben, I might have figured it out for you..

–PFL Buttons are CC33 + CC34
–PFL Meters are CC82 + CC83
–Master Meters are CC80 + CC81

I think everything is on Channel 1.

This is my interpretation of the Hex information in the manual found here.

@Stewe, I’ve just looked into Hex for the first time. I presume you might know a bit about it so, of course, point out anything I might have misunderstood. Also, it’d be great if you could share any general insight on the topic. I still don’t understand where to get channel information from!

8

Thanks for the help! I got the LEDs working in Traktor with your tips.

However, the PFL buttons refuse to lighten up, no matter what I do. Should I give them some specific range or something?

9

Upload your controller .tsi and I’ll have a look at it. Probably a quick & simple fix.

10

Ha, got it working!

Instead of giving the cc id of the PFL button, Ch01.CC.33 or Ch01.CC.34, I needed to give the note: Ch01.Note.A1 or Ch01.Note.A#1

Thanks anyway!

11

Awesome! Post it on the mappings page in case someone else is stuck on it and doesn’t come across this thread.

12

Bax in the Netherlands had these last week for 19 euro :thumbsup:
I have no use for it but could not resist. It will be used somewhere, someday or just for parts

13

I’m also trying to map the PFL and master LEDS..
I’ve done everything here in this topic but it’s still not working :disappointed:

You can check my .tsi file at http://www43.zippyshare.com/v/Vy6IBvMr/file.html