NI Kontrol Z1 + 2x Stanton SCS3D…is this possible?
Hi all…first time poster, long time follower!
I currently own a Stanton SCS System 3 MIDI controller running Traktor Pro. Despite the lack of support, and Stanton’s takeover by Gibson (which is akin to banging your head to a Republican wall), I’m quite happy with my setup, except that I never was keen on the SCS3M mixer unit…nothing beats a tactile hardware mixer, even after almost 25 years of spinning on every format throughout that period.
Now that I have seen what the NI Kontrol Z1 offers, I seem to have found the answer to my prayers, especially since I stuck to the traditional 2-deck setup. Plus, its size compliments my need to keep it all portable. Is it possible to combine the Z1 with the two SCS3D deck units, and if so, how do I go about doing it? I admit that I find the proprietary DaRouter/Bome’s utility to be very deep in terms of learning curve and fiddling about, so I’m more than open to your expert advice and solutions.
There isn’t really anything to “fiddle about” with in DaRouter. You load a preset and go. But in any case, you don’t need to make any change at all with DaRouter apart from selecting a different preset (maybe the generic dual SCS.3d if you want to make a mapping). The Z1 will have it’s own support in Traktor (like every other NI controller).
Hi nem0nic. Good to see that you’re here…used to follow you on the Stanton forums.
So, the way I’m imagining it, the Z1 would not interfere with the SCS3D’s, 2 USB slots will be used instead of the one that chains my current system, and Traktor will take care of the Z1 whilst DaRouter will still be needed to take care of the two SCS3D’s. Should I keep an eye out for anything else?
