Simple but difficult

DJ Software & Apps Controller Mappings
,
1

Simple but difficult

So I’ve been working on a MF3D mapping for about 3 weeks now and am completely stuck. I’ve looked for tutorials and videos and have found nothing. So if you guys could answer these following questions for me, it would be greatly appreciated:

  1. How do I set the banks to control different decks (I.E. Bank A = Deck A, Bank B, Deck B, etc.)?

  2. How do I map buttons with the same effect but with different values (I.E. Beatmasher effect)?

  3. How would I map knobs to trigger when I rotate the MF (I.E. Filter knob, Key knob, FX knob)?

  4. How do I map remix decks?

  5. How do I map the side buttons to scroll the pages on the remix decks?

I know this is a lot, but once I get this done, it’ll be a really useful mapping.

Thanks.

2

  1. Use MF Utility software. Ensure “Four Banks Mode” is enabled then send new settings to the Midifighter.

  2. Check the Ultimate FX Thread sticky in this forum. You’ll find all the parameters for that mapping.

  3. I can help you with this - what in particular do you have in mind for each motion/direction?

  4. I’d rather suggest you search DJTT MAPS site for Spectra Remix Deck mapping. This mapping will also work with your 3D and it already has decks C and D all mapped inside out including VU metering LED’s for each sample cell.

  5. That mapping already has sample page selector in side buttons. But in this case, you’ll probably have to remap this commands since 3D is sending different side button midi messages than the Spectra does.