Twister: Bank 2,3,4 repeat Bank1 (even after Factory Reset)
After a Factory Reset the rotary encoders are set with an “Encoder MIDI number” from 0 to 63 between Bank 1 and Bank 4 but only Bank 1 works. Banks 2, 3 and 4 repeat exactly the “Encoder MIDI numbers” of the Bank 1 despite being set differently to get up to 63.
Any attempt to set different parameters on Banks 2,3 and 4 is useless, only Bank 1 receives the changes and applies them.
In the image you can see that I move the encoder to the bottom right in Bank 4 but instead of seeing “B0 3F” (0x3F = 63) there is “BO 0F” (0x0F = 15) which is the corresponding value of Bank 1!
It’s not correct behavior. Is it a factory problem or do I have to load a specific firmware to work in MIDI class compliant mode?
