Simply need more options on your controller or wish to push your Traktor mapping potential to the max? This is a mapping technique you’ve been looking for.
Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 1 Add out modifier #1
Controller range - 1 to 1
Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 2 Add out modifier #1
Controller range - 2 to 2
Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 3 Add out modifier #1
Controller range - 3 to 3
Add in modifier #1
Type of Controller = Button
Interaction mode = Direct
Value = 4 Add out modifier #1
Controller range - 4 to 4
is it possible to map them blinking? i had the idea to map a beatphase monitor out to each button, but since its connected to a specified deck or focus it won’t work…
oh i forgot - the xone k2. at the moment i mapped four beatphase monitors per button (A,B,C,D) since at least one deck is running - but i think its not a clean solution.
ok, thx for the advice. you mean the normal phase instead of the beatphase?
had hoped that there is a better solution. but somehow i get used to map x commands for one function.
Still can’t get the bloody thing to work I have my 8 Buttons mapped to specify values and to turn on looping. Now I have each of those buttons mapped to change the modifier directly 0-7. Any help on mapping the LED output. Please.
Wont work. Closest thing Ive got is just a light up when its on the correct value. What should I use as my out message like, Loop Size select and Set or the Modifier?
That should be easy as assigning modifier condition ‘Is in Active loop’ to Loop Size Selector LED outputs.
Add out > Deck Common > Loop > Loop Size Selector
modifier condition - Is in Active loop (will lite only if loop engaged)
controller range - 0-0 (example for /32)
I know it doesnt make sense to have the modifier on the “Loop Active ON” switch but it seems to work better (could just be my controller). I am running TSP 2.6 with a Novation launchpad, External mixer and a remote zero for FX. My LED Output range is actually 10-19 (red - orange) but the default 0-127 (ON/OFF) should be fine or change it as you need it. I had this running with 4 decks a while back. I just might set that up again.
Invert and Blend are unchecked for all parameters.
Bank2: only browser on (in) M1=2
only browser on (out) / midi range 3/124 /// M1=2
When I press Bank2 the browser button lights up and works perfectly. When I switch back to bank1 the browser button is still there lighten up although uneffective.
