Have had my Num Mixtrack Pro for a year now and still cant get my headphones to work.

DJ Life & Community General Discussion
1

Have had my Num Mixtrack Pro for a year now and still cant get my headphones to work.

Hi guys,

This is my setup.

Numark Mixtrack Pro, Compaq CQ70, Pioneer HDJ1000, Traktor Pro 2

I have it setup that the audio device is Asio4all and Built in sound card set to Asio4all. ( I have tried many forums for help and have had no luck).

Conexant HDaudio is also available to choose.

As I speak I have my headphones plugged into the headphone jack, the rear of the mixtracks outputs (1) are plugged into speakers, and mixtrack pro usb is plugged into the laptop.

Traktor Pro 2 running it shows me that Output master and Output Monitor have HDaudio headphone 1 and 2 available for both. Nothing else

One week I had it working to cue tracks and that. Then the next day (did not change any settings) it wouldnt work?

Very confusing and frustrating.

If anyone can help, it would be much appreciated.

Da3dalus

2

Please someone if you could help me out.

Its so frustrating :disappointed:

Should I just buy an external audio dj 2? I would rather use the sound card in the Mixtrack Pro rather than forking out for the audio dj.

Any suggestions or anyone had this problem before?

Thanks

Da3dalus

3

It sounds to me that your asio4all drivers are not working correctly.

I am not familiar with the technical details of the mix track pro but you should have more than 2 channels available in the audio output section.

Is asio4all the correct drivers for the mix track pro?

4

make sure you dont have anything else open ie itunes … unplug your controller wait for it to light up then open up traktor

make sure that asio4all is selected on the audio device and the built in sound card bit..

then go to your output routing make sure mixing mode is to internal

output monitor should be 3 and 4

output master should be 1 and 2

hope this helps if it doesnt go to numarks website they should sort you out

5

@Sean_Boy87

Setting the output routing your way worked.

Thank you so much :slight_smile:

As usual something as simple as that lol.

@Kaek

Thanks aswell for your help :slight_smile: