Instant FX effect buttons that switches FX panel mode

DJ Software & Apps Controller Mappings
, ,
1

Instant FX effect buttons that switches FX panel mode

I am setting up a new mapping, but have run into a problem.

As the setup is quite massive (two launchpad Minis, one Behringer CMD LC-1, a Novation Launch Control XL and a Midifighter Twister.

As I have many buttons with lots of commands in each of them, I am mapping many “one press” effect buttons. As some are using a “singe” effect and some are using “group” effect, I have mapped the button the switch Panel Mode as well as setting up all effect parts.

The problem is that Traktor send the switch panel mode command after all the others, so all the setup effects are not applied when the modes is changes. As I can’t control the order of the command applied to a button, I don’t know how to overcome this problem.

Any insight on ho to solve this?

I use a Macbook Pro with OSX 10.10.2 and using Traktor Pro 2.7.3

Jeppe Johansen

2

Adding the Store Preset command any help?

Just map it to your effect buttons and see if that works.

Add In > FX Unit > FX Store Preset

3

Allready done, but doesn’t work for this problem.

4

Hmmm.. Did you also add the FX Panel Mode modifiers for each state?

5

Problem still applies

6

If the problem still applies, even with my provided keyboard mapping, there might be problem with your Traktor.

7

You mapping only contained setup for FX not any keyboard or controller mapping

8

I see, must have had tick and exported the Controller Mappings in stead of Keyboard.
But still, my mapping only worked once - if I restart Traktor the same problem would be there. Trick is to save snapshot ON STATE for both unit modes before using mappings. Than it should work.

edit: