VCI-100 fw 1.4, and TSP2/TS2

DJTT Gear & Custom Mods DJ TechTools' VCI-100 Product Support
1

VCI-100 fw 1.4, and TSP2/TS2

(Admins: if this is in wrong forum, apologies-please relocate)
Hi all,
It has been a while since I’ve used Traktor w/my Vestax VCI-100. I’ve since updated my Mac’s operating system. I now am using 10.7.5, TSP 2.6.3, an NI Audio10 soundcard, and the Vestax VCI-100 w/1.4 firmware. It took me a while to update the soundcard drivers/firmware, and now I have sound. However, I cant seem to get my computer to see the Vestax controller. I used the VCI-100se v4.1 (T2) tsi, selected Vestax vci-100 under device setup, in-port, and out-port, and nothing. I used the setup wizard to select the vci-100, and still nothing. The Vestax is lighting up, and sending out signals.

Perhaps I’m missing a step?

Maybe I need to ask: does the VCI-100 work with TSP2/TS2? If so, which .tsi do I need to use? (I need basics, sometimes I sync, sometimes I beatmatch-I dont use samples/remix sets, but I do use FX) I don’t feel comfortable doing any midi mapping. I understand the concepts but don’t have time for the learning curve.
If anyone can help answer these questions, it would be appreciated.:thinking:
(Admins: if this is in wrong forum, apologies-please relocate)

2

Would be good idea to try out different computer or USB cable too. I don’t see why Traktor wouldn’t recognize the unit unless the unit is defective or your drivers got all mess in operative system.

3

moved

4

Thanks for the reply. I tried the easier of the 2 suggestions-I swapped the cable. I feel like a goof :open_mouth: Thanks again!

5

No worries mate, glad that sorted it!